DYNAMIC ANALYSIS AND QUANTITATIVE FAULT CHARACTERISATION OFA THREE-PHASE INDUCTION MOTOR USING d-q TRANSFORMATIONAND MATLAB/Simulink
Keywords:
induction machine , d-q transformation , Matlab/SimulinkAbstract
Three-phase induction motors are widely used in industrial drive systems, where electrical faults can produce significant disturbances in current, electromagnetic torque, and rotor speed. This study presents dynamic modelling and quantitative fault characterisation of a three-phase induction motor using the d-q transformation and MATLAB/Simulink. The developed model was used to investigate the motor under no-fault, three-phase symmetrical fault, and unsymmetrical line-to-ground (L-G), line-to-line (L-L), and double line-to-ground (L-L-G) fault conditions. The dynamic responses were evaluated using peak stator current, RMS stator current, minimum rotor speed, percentage speed reduction, minimum electromagnetic torque, peak-to-peak torque variation, and phase current imbalance. Under the no-fault condition, the motor attained a steady-state speed of approximately 1800 rpm. The three-phase fault resulted in a small speed reduction to approximately 1734.14 rpm and a minimum electromagnetic torque of −71.71 Nm. The L- G fault produced a comparatively smaller speed reduction to approximately 1764.10 rpm, although significant current and torque disturbances were observed. The L-L fault produced the highest peak stator current of approximately 226.62 A and the largest peak-to-peak torque variation of 319.49 Nm, while the L-LG fault produced the phase current imbalance of 70.69%. The results demonstrate that fault severity is dependent on the performance metric considered and that no single dynamic variable is sufficient to comprehensively characterise induction-motor fault behaviour. The proposed quantitative fault characterisation provides useful complementary dynamic indicators for quantitative comparison of induction motor fault responses and provides a simulation-based foundation for subsequent condition monitoring and fault classification studies.
Published
How to Cite
Issue
Section
How to Cite
Similar Articles
- Falade K. I., ON MATHEMATICAL PROJECTION OF NIGERIA POPULATION USING NUMERICAL TECHNIQUES , FULafia Journal of Science and Technology : Vol. 5 No. 2 (2019): Fulafia Journal of Science and Technology (FJST)
- Moses Anayo Mbah, Faith U. Attama, David T. Achaku, A GRAPH-THEORETIC STUDY OF TRANSFORMATIONS WITH ORDER-PRESERVING ANDCONTRACTION RESTRICTIONS ON A FINITE CHAIN , FULafia Journal of Science and Technology : Vol. 11 No. 1 (2027): Fulafia Journal of Science and Technology (FJST)
- Olanipekun M. U., Olanipekun A. J., Amusa K. A., Opeodu A. J., PARAMETERS EXTRACTION OF A DOUBLE-DIODE MODEL OF PHOTOVOLTAIC CELL USING NEWTON-RAPHSON METHOD , FULafia Journal of Science and Technology : Vol. 4 No. 2 (2018): Fulafia Journal of Science and Technology (FJST)
- Fenuga O. J., Ayeni B. O., NEW RESULT ON A FLUID FLOW INDUCED BY A ROTATING MAGNETIC FIELD , FULafia Journal of Science and Technology : Vol. 4 No. 2 (2018): Fulafia Journal of Science and Technology (FJST)
- Abubakar M. I., Adeshina I., Ayeloja A. A., Abdulraheem I., INDUCTION OF NORMOCYTIC-NORMOCHROMIC ANAEMIA IN Clarias gariepinus (Burchell, 1822) EXPOSED TO ACUTE CONCENTRATION OF 1, 1-dimethyl 4,4-bipiridillium (PARAQUAT) UNDER LABORATORY CONDITIONS , FULafia Journal of Science and Technology : Vol. 5 No. 2 (2019): Fulafia Journal of Science and Technology (FJST)
- Waliu Olalekan Apena, Step-Index Plastic Optical Fibre (SI-POF) Channel Optimisation: M-PAM and Equalization , FULafia Journal of Science and Technology : Vol. 6 No. 1 (2020): Fulafia Journal of Science and Technology (FJST)
- Okonofua E. S., Babalola J. O., Ojuri O. O., GEOENVIRONMENTAL ASSESSMENT OF TOTAL PETROLEUM HYDROCARBON CONTENT IN OLOGBO FIELD, NIGER DELTA, NIGERIA , FULafia Journal of Science and Technology : Vol. 5 No. 1 (2019): Fulafia Journal of Science and Technology (FJST)
- Obaje S. O., GRANULOMETRIC AND GEOCHEMICAL ASSESSMENT OF AJALI SANDSTONE IN FUGAR AREA IN BENIN FLANK OF ANAMBRA BASIN, NIGERIA , FULafia Journal of Science and Technology : Vol. 5 No. 2 (2019): Fulafia Journal of Science and Technology (FJST)
- Odugbose B. D., Raji A. O., Akinyemi O. o., Sule S. O., Babalola A. A., SOUND EFFECTS OF OCCUPATIONAL NOISE EXPOSURE ON PERSONNEL IN BURR MILL PROCESSING CENTRES , FULafia Journal of Science and Technology : Vol. 5 No. 2 (2019): Fulafia Journal of Science and Technology (FJST)
- A. M. Oyelakin, Salau-Ibrahim T. T., Ogidan B. S., Azeez R. D., Ajiboye I. K., PEER-TO-PEER BOTNETS: A SURVEY ON PROPAGATION, DETECTION AND DETECTION EVASION TECHNIQUES , FULafia Journal of Science and Technology : Vol. 5 No. 2 (2019): Fulafia Journal of Science and Technology (FJST)
You may also start an advanced similarity search for this article.
